Operation - Desa VO36NR Mode D'emploi

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: Keep flue open
when operating unit.
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted with a piezo ignitor. When
lightning the pilot, follow these instruc-
tions exactly.
b. bEFORE LIGHTING smell all around
the appliance area for gas. be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
gas control knob. Never use tools. If
the knob will not push in or turn by
hand, do not try to repair it, call a quali-
fied technician. Force or attempted
repair may result in a fire.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information,
above.
2. Make sure switch is in the OFF position.
3. Be sure gas line shut-off valve is OPEN.
4. Press in and turn control knob clock-
wise to the OFF position (see
Figure 18).
12

OPERATION

Note: Knob cannot be turned from PILOT
to OFF unless knob is pushed in slightly.
DO NOT FORCE.
5. Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow "B" in
the safety information in column 1. If you
don't smell gas, go on the next step.
6. Press in and turn control knob counter-
clockwise
Press in control knob for five (5) seconds
(see Figure 18).
7. With control knob pressed in, press and
release ignitor button. This will light pilot.
If needed, keep pressing ignitor button
until pilot lights.
Note: If pilot does not stay lit, contact a
qualified service person or gas supplier
for repairs.
8. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop out when
released, turn off gas supply and contact
a qualified service person or gas supplier
for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
9. Slightly push in and turn control knob coun-
terclockwise
10. Wait one minute and move switch to the
ON position to light burner.
Note: AUTO is only functional when using
optional remote control accessory.
11. Set flame adjustment knob to any level
between HI and LO.
Control
Knob
Piezo
Ignitor
Figure 18 - Setting Control Knobs
1. Push switch into OFF position. The pilot
will remain lit for normal service.
2. Access control knobs.
3. Press gas control knob slightly and turn
clockwise to OFF. Do not force.
4. Close equipment shutoff valve (see Figure
14, page 10).
www.desatech.com
to the PILOT position.
to the ON position.
Flame Adjustment Knob
TO TURN OFF GAS
TO APPLIANCE
119109-01G