Inspecting Burners - Desa VO36NR Mode D'emploi

HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 12.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Slide the selector switch
to the REMOTE position (see Figure 19).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
Control Knob
Flame
Piezo
Adjustment
Ignitor
Knob
Figure 19 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame height. Alterations may have
occurred during shipping and handling. Call
a qualified service person to readjust the pilot
if necessary.
The height of the thermopile must be 3/8" to
1/2" above the pilot flame as shown in Figure
21. The thermocouple must be at a height of
about 1/8" above the pilot flame. The flame
from the pilot burner must extend beyond both
the thermocouple and thermopile.
If you pilot assembly does not meet these
requirements:
• turn fireplace off (see To Turn Off Gas to
Appliance, page 12)
• see Troubleshooting, page 16
119109-01G
OPERATION
Continued
REMOTE
OFF
ON
Selector Switch in
REMOTE Position

INSPECTING bURNERS

www.desatech.com
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 20).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 20 - On/Off Hand-Held Remote
Control Unit (HRC100)
Thermopile
3/8" to 1/2"
Piezo
Ignitor
Figure 21 - Pilot Assembly
Control
Button
Pilot Burner
1/8"
Thermocouple
13