Cleaning And Maintenance - Desa VO36NR Mode D'emploi

BURNER FLAME PATTERN
Figure 22 shows correct burner flame pattern.
NOTICE: Do not mistake orange
flames with yellow tipping. Dirt
or other fine particles are burned
by appliance, causing brief
patches of orange flame.
If burner flame pattern is incorrect, as shown
in Figure 23.
• turn appliance off (see To Turn Off Gas to
Appliance, page 12)
• see Troubleshooting, page 16
WARNING: Turn off the ap-
pliance and allow to cool before
cleaning.
CAUTION: You must keep
control areas, burners and cir-
culating air passageways of fire-
place clean. Inspect these areas
of fireplace before each use. Have
fireplace and chimney (if appli-
cable) inspected yearly by a quali-
fied service person. Fireplace may
need more frequent cleaning due
to excessive lint from carpeting,
bedding material, etc.
14
INSPECTING bURNERS

CLEANING AND MAINTENANCE

www.desatech.com
Continued
Figure 22 - Correct Burner Flame Pattern
Figure 23 - Incorrect Burner Flame
Only limited cleaning will be required under
normal use of this appliance. Dust the front
grate and top of receiver/valve. Do not use
cleaning fluids to clean logs or any other part
of the appliance.
If, after a period of use, the flames start to
exhibit unusual shapes and behavior or the
burner fails to ignite smoothly, then the burner
holes may require some cleaning. If this hap-
pens, we recommend that you contact your
nearest authorized service technician to get
the appliance serviced.
• Keep area around log set clean and clear
of debris.
• Periodically inspect the air mixer and burner
tube for foreign matter blocking the air inlet
and flame holes.
Yellow Flames with
Orange Streaks
Dark Orange
Flames
Pattern
119109-01G