JUNO JCN12220S5 Notice D'utilisation page 23

Problem
The compressor operates
continually.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger‐
ator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor‐
rectly.
During the automatic de‐
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
Solution
Refer to "Replacing the
lamp".
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
23