Télécharger Imprimer la page

Renfert hotty Mode D'emploi page 8

Masquer les pouces Voir aussi pour hotty:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
3.1 Liability Exclusion
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those cited in the operating instructions;
EN
► The product is altered in any way other than those alterations described in the operating instruc-
tions;
► The product is repaired by other than an authorized facility or if any but Renfert OEM parts are
employed;
► The product continues to be employed, despite obvious safety faults;
► The product is subjected to mechanical jarring or is dropped.
4
Operating Elements
(Fig. 1)
A)
On / Off switch
B)
Lid
C) LED indicator
>> Operation LED = green
>> Warm-up phase = red
D) Power cord
E)
Wax pot
F)
Potentiometer
5
Commissioning / Operation
1.
Connect the hotty to the wall outlet (Fig. 2).
2.
Swivel the cover (B) back (Fig. 3).
3.
Add the dipping wax to the pot (E) (Fig. 4).
4.
Switch the hotty on at the main power switch (A).
The operation LED (C - green) then goes on. During the warm-up phase the red LED (C) also
remains on.
5.
Turn the potentiometer (F) that gives you setpoint between 60 °C [140 °F] and 110 °C [230 °F] in
increments of 10 °C [18 °F] until you reach the desired operating temperature (Fig. 5).
6.
Once the unit reaches the setpoint temperature, the red LED goes out (C). The red LED would light
up shortly when regulating the temperature successively.
5.1
Correct dipping
(Fig. 6)
• Support the hand comfortably.
• Do a quick dip to just beyond the preparation border.
• Slowly and evenly remove the die from the wax.
• Just before the tip comes out hold it steady in the pot for a short time so that any excess wax can drip
down.
6
Cleaning / Maintenance
The hotty is maintenance free. From time-to-time, you should wipe your unit down with a damp cloth.
Never use detergents or solvents!
Never rinse or spray your
hotty directly with water.
With the unit switched off, you can remove hardened wax residue by carefully scraping it.
Warming the unit's surfaces with a hair drier will make it easier to remove wax residue.
7
Spare Parts
You can find components subject to wear and the spare parts on the spare part list in the
internet at www.renfert.com/p918.
Enter the following item number: 14400000 or 14401000.
The components excluded from the warranty (such as consumables or parts subject to wear
and tear) are marked on the spare part list.
Serial number and date of manufacturing are shown on the type plate of the unit.
- 2 -

Publicité

loading