Troubleshooting - Scheppach WSE1000 Traduction Des Instructions D'origine

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste electri-
cal and electronic equipment.

15. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
Malfunction
The machine will not switch on
No ignition spark
30 | GB
Improper handling of waste equipment may have neg-
ative consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic equip-
ment. By properly disposing of this product, you are al-
so contributing to the effective use of natural resourc-
es. You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Possible cause
No mains voltage
The main fuse has tripped
On / off switch defective
Motor defective
Earth clamp not connected to the
device /
Earth clamp not fitted on the
workpiece
www.scheppach.com
Remedy
Check the socket, mains cable, cable,
mains plug; have these repaired by a
qualified electrician if necessary.
Check the main fuse
Repair by customer service department
Repair by customer service department
Connect the earth clamp to the welding
machine /
Fit the earth clamp on the workpiece.