koban KPA-20 Manuel D'instruction page 32

Warning: To avoid possible electric shock or
personal injury, and to avoid possible damage to the
Meter or to the equipment under test, adhere to the
following rules:
 Before using the Meter inspect the case. Do
not use the Meter if it is damaged or the case
(or part of the case) is removed. Look for
cracks or missing plastic. Pay attention to
the insulation around the connectors.
Inspect the test leads for damaged insulation

or exposed metal. Check the test leads for
continuity.
 Do not apply more than the rated voltage, as
marked on the Meter, between the terminals or
between any terminal and grounding.
 The rotary switch should be placed in the right
position and no any changeover of range shall
be made during measurement is conducted to
prevent damage of the Meter.
 When the Meter working at an effective voltage
over 60V in DC or 30V rms in AC, special care
should be taken for there is danger of electric
shock.
 Use the proper terminals, function, and range
for your measurements.
 Do not use or store the Meter in an
environment of high temperature, humidity,
explosive, inflammable and strong magnetic
field. The performance of the Meter may
deteriorate after dampened.
 When using the test leads, keep your fingers
behind the finger guards.
Disconnect circuit power and discharge all

high-voltage capacitors before testing
- 32 -