General Information; Contact Address; Warranty; Informations In The Internet - Burkert AirLINE 8644 Mode D'emploi

General information
note!
operate the system with direct current only!
To prevent damage to the system, use only direct current for the
system power supply.
prevent a pressure drop!
To prevent a pressure drop, design the system pressure supply
with the largest possible volume.
electrostatic sensitive components/modules!
The device contains electronic components, which react sensitively
to electrostatic discharge (ESD). Contact with electrostatically
charged persons or objects is hazardous to these components. In
the worst case scenario, they will be destroyed immediately or will
fail after start-up.
• Observe the requirements in accordance with EN 61340-5-1
and 5-2 to minimize/avoid the possibility of damage caused by a
sudden electrostatic discharge!
• Also, ensure that you do not touch electronic components when
the power supply voltage is present!
Type 8644
5. General inFormaTion
5.1. contact address
germany
Bürkert Fluid Control Systems
Sales Center
Christian-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: info@de.buerkert.com
international
Contact addresses are found on the final pages of this operating
manual.
And also on the Internet under: www.burkert.com

5.2. Warranty

The warranty is only valid if the AirLINE Type 8644 is used as intended
in accordance with the specified application conditions.
5.3. informations in the internet
The operating manual and the data sheets on Type 8644 can be found
on the Internet under: www.burkert.com
english
7