Installation; Safety Instructions; Fluid Installation - Burkert AirLINE 8644 Mode D'emploi

9.

insTallaTion

9.1. safety instructions
Danger!
risk of injury from high pressure in the equipment!
• Before loosening lines or valves, turn off the pressure and vent
the lines.
risk of injury due to electrical shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
Warning!
risk of injury from improper installation!
• Installation may only be carried out by authorized technicians with
the appropriate tools!
risk of injury from unintentional activation of the system and
uncontrolled restart!
• Secure system from unintentional activation.
• Following installation, ensure a controlled restart.
Type 8644
Installation
9.2. Fluid installation
Danger!
risk of injury from high pressure in the equipment!
• Before loosening lines or valves, turn off the pressure and vent
the lines.
• Design the connections with the largest possible volume.
• Close the open connections not required with lock screws.
• The connections for the pilot control exhaust air (x) must not be
sealed.
• Check correct assignment of the connections 1 and 3 or 5. They
may by no means be interchanged.
9.2.1. pneumatic connections - feed
Fig. 14: Pneumatic Connections
english
(R/S) 3/5
Exhaust air
X channel:
Standard version:
Deaeration of the control valves
Control assist air version:
P connection for control valves
(P) 1
Pressure supply connection
17