Assembly - Burkert AirLINE 8644 Mode D'emploi

Structure and installation

8.3. assembly

8.3.1. installation on standard rail
Danger!
risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
Fig. 6: Installation of a valve block into a control cabinet
→
Fasten the standard rail firmly in the control cabinet.
→
Establish a short, wide PE connection between the standard rail
and the control cabinet.
The valve terminal must be freely accessible from above.
Ensure good heat dissipation!
recommended distance when installing in a control cabinet:
a 30 mm
b 30 mm
Type 8644
c 30 mm
d 60 mm
8.3.2. installation of airline Quick
To install AirLINE Quick, a notch must be first of all provided on the
base or the wall of the control cabinet, e.g. through lasing or punching.
For the dimensions of the relevant flange image, refer to chapter
"8.3.3. Dimensions of the flange images for AirLINE Quick".
note!
The notch on the control cabinet base must be burr-free for the seal
of the AirLINE Quick adapter not to become damaged.
→
Place the valve terminal in the control cabinet on the prepared
notch.
Fig. 7: Placing the valve terminal in the control cabinet
english
Valve terminal
Type 8644
AirLINE Quick
adapter
Control cabinet
13