Electrical Installation; Start-Up; Safety Instructions; Fluid Start-Up - Burkert AirLINE 8644 Mode D'emploi

3/2-way valve variants
Working connection
Top (0) Sealed internally
Bottom (2)
procedure:
→
Depending on the version, plug the connections in the corre-
sponding working connections (D6, D1/4) or screw them in (M7).
→
Connection nipples can be used for threaded versions.
inscription of the connections:
→
Label the inscription areas with the data of the valve
connections.
9.3. electrical installation
Danger!
risk of injury due to electrical shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
The electrical installation of the AirLINE system corresponds to the
installation of the decentralized peripheral device (depending on the
relevant cooperation partner Siemens, Wago, Phoenix or Rockwell).
Refer to the manuals provided by the cooperation partners for a more
detailed description.
Type 8644

Start-Up

Variant 1 Variant 2
Sealed internally
M7 D6, D1/4
10. sTarT-up
10.1. safety instructions
Warning!
risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
• Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
• Observe the safety instructions and intended use.
• Only adequately trained personnel may start up the equipment/
the device.
10.2. Fluid start-up
note!
• Switch on the supply pressure.
• Only then switch on the power supply!
procedures before fluid start-up:
→
Check connections, voltage and operating pressure.
→
Ensure that max. operating data are not exceeded.
→
Check correct assignment of the connections 1 and 3 or 5. They
may by no means be interchanged.
→
Release manual actuation during electrical operation.
english
19