Warning - Caution - Vortice LINEO V0 Notice D'emploi Et D'entretien

Table des Matières

Publicité

WARNING – CAUTION
Warning:
• Do not use this appliance for functions other than
those described in this instruction booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified technician
or contact Vortice*. Do not leave packaging within
the reach of children or infirm persons.
• Certain fundamental rules must be observed when
using any electrical appliance: a) never touch
appliances with wet or damp hands; b) never touch
appliances while barefoot; c) never allow children
or infirm persons to use the appliance unattended.
Caution:
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.)
• The inside of the appliance should be cleaned only
by qualified personnel (figs. 26-27).
• Do not immerse the appliance or any parts of it in
water or other liquids. Refer to the relevant
instructions to clean the appliance (fig. 28).
• Regularly inspect the appliance for visible defects.
If any are found, do not operate the appliance and
contact Vortice* immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice* immediately and
ensure that only original Vortice spares are used
for any repairs.
• Should the appliance be dropped or suffer a
heavy blow, have it checked immediately by
Vortice*.
• The appliance must be installed by a professionally
qualified electrician.
• The electrical system to which the appliance is
connected must conform to applicable standards.
• The appliance is double insulated and therefore
does not need to be earthed.
• The electrical power supply / socket to which the
appliance is to be connected must be able to
provide the maximum electrical power required by
the appliance. If it cannot do this, contact an
electrician to make the necessary modifications.
• A multi-pole switch must be used to install the
appliance. The gap between the switch contacts
must be no less than 3 mm.
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function
correctly; b) before cleaning the outside of the
appliance; c) if the appliance is not going to be
used for any length of time.
*(or an authorized Vortice dealer if you are outside the UK-Ireland territory)
10
this symbol indicates precautions that must be taken to avoid injury
this symbol indicates precautions that must be taken to avoid damaging the
appliance
• Store the appliance out of reach of children and
infirm persons if you decide to disconnect it from
the power supply and no longer use it.
• Do not operate the appliance in the presence
of inflammable vapours (alcohol, insecticides,
petrol, etc.)
• Do not sit or place objects on or in the appliance.
• Do not allow young children or infirm persons to
use the appliance without supervision.
• Supervise young children to ensure that they do
not play with the appliance.
• The appliance cannot be used to control activation
of water heaters, room heaters, etc. and it must
not exhaust into the hot air flues of such
appliances.
• The room must have an adequate source of
replacement air for this appliance to function
effectively. Moreover, if there is any non-sealed
combustion based appliance such as a water
heater, gas stove, etc. in the same room, air
replacement must be sufficient for all appliances to
work effectively together.
• The appliance must discharge into a single duct
(dedicated to this product).
• Keep the appliance's inlet and outlet grilles free to
ensure an optimum flow of air.
• The appliance's outlet port must always be
connected to a suitable duct.
• The maximum ambient temperature for proper
functioning of the appliance is as follows: Max 60°C
N.B.
• When the appliance is installed at a height
lower than 2.3 m it is obligatory that (fig. 3):
• the frame with safety screen, when the short
duct is connected to the outlet port (to
prevent access).
• the protective grille is fitted when the inlet
port is not ducted (free intake).
• All versions of 100-125-150-160-200 appliances
are fitted with a safety overtemperature device.
• Versions of 250-315 appliances are equipped
with a manual-reset safety device to shut down
operation in the event of fault. If the device
cuts in, disconnect the appliance, allow it to
cool, eliminate the cause of the fault (e.g. grille
obstruction, fan fault, duct obstructions), then
reconnect the appliance. If the safety device
continues to cut in, have the appliance checked
by Vortice*.
ENGLISH

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lineo t v0

Table des Matières