Commissioning - Kübler 573 Serie Mode D'emploi

7. Commissioning

Commissioning of this unit is easy and uncomplicated when following the subsequent steps:
Step
1 Analogue inputs
2 Basic settings
3 Parameter settings
4 Supplementary
functions
A Set-Up Form is available in the appendix of this manual, which may be used for a most
convenient and clearly arranged setup procedure.
It is advisable to do settings for Tare and linearisation functions quite at the end, after all other
functions have already proved to work fine.
6.573.011.E00_7b_e.doc / Sep-08
Action
• Set jumpers
• Select Operation mode
• Keep linearisation and Tare function off firstly
• Configuration of the analogue inputs, scaling
of the display
• If applicable, select combination and final
scaling
• Configuration of switching outputs
• Set Tare function and Linearisation, if
applicable
See section
3
6.1
6.1
6.4
6.4.3
6.4.4
8
Page 21 / 28