The Parameter Menu - Kübler 573 Serie Mode D'emploi

5. The Parameter Menu

The menu provides one section with "basic parameters" and another section with "operational
parameters". On the display you will only find those parameters which have been enabled by
the basic settings. E.g. when the Linearisation Functions have been disabled in the basic set-
up, the associated linearisation parameters will also not appear in the parameter menu.
All parameters, as good as possible, are designated by text fragments. Even though the
possibilities of forming texts are very limited with a 7-segment display, this method has proved
to be most suitable for simplification of the programming procedure.
The subsequent table is to show the general structure of the whole menu only.
Detailed descriptions of all parameters will follow in section 6.
Menu overview:
Basic Parameters
„n)odE"
„briGht"
"UPdAt"
„CodE „
„LinEAr"
"Crnd"
„CHAr 1"
„CHAr 2"
„HYSt 1"
„HYSt 2"
*) appears only
when Tare function is-
enabled
**) appears only
when linearisation is
enabled
6.573.011.E00_7b_e.doc / Sep-08
Operational Parameters
Single Mode Dual Mode
„PrES 1"
„PrES 2"
„inPutA" „inPutA"
„StArtA" „StArtA"
„End A" „End A"
„dPoi A" „dPoi A"
„FiLt A" „FiLt A"
"OFFS A" *) "OFFS A" *)
„inPutb"
„StArtb"
„End b"
„dPoi b"
„FiLt b"
OFFS b" *)
"P01_H " **)
"P01_Y " **)
"P16_H " **)
"P16_Y " **)
Combined Modes
„inPutA"
„StArtA"
„End A"
„dPoi A"
„FiLt A"
„inPutb"
„StArtb"
„End b"
„dPoi b"
„FiLt b"
„n) FAc"
„d FAc"
„P FAc"
„dPoint"
---->
Page 12 / 28