Menu Text
Command key enable
6.2. Operational parameters
After the basic setup, you can access the operational parameters by pressing ENTER for at
least 3 seconds. You will only find those parameter texts that are relevant for your mode of
operation.
To exit the menu, keep again ENTER down for at least 3 seconds, or just wait for the automatic
Time-Out function.
6.3. Keypad locking
When the code locking of the keypad has been switched on, any key access first results in
display of
To access the settings, within the next 10 seconds you have to press the key sequence
or the unit will automatically return to the normal display mode
6.573.011.E00_7b_e.doc / Sep-08
The Command key is switched off and no Offset
values will appear in the menu
The Cmd key will execute the Tare/Offset function
The Cmd key will execute the Teach function
The Cmd key will execute both, the Tare and the
Teach function
Default
Page 14 / 28