Setting The Timer; Setting The Humidity Level; Water Level; Refilling Reservoir - Philips HU4805 Mode D'emploi

Setting the timer

With the timer function, the humidifier
can operate for a set number of hours.
When the set time has elapsed, the
humidifier automatically turns off.
1
Press the timer button
more times to choose the number
of hours you want the humidifier to
operate (fig. n).
» The corresponding timer light
(1H, 4H or 8H) goes on.
To deactivate the timer function, press
the timer button repeatedly until the
timer light turns off.

Setting the humidity level

Note
•
Make sure that the reservoir is filled
with water before turning it on. (see the
chapter 'Get started', section 'Prepare for
humidification').
•
The humidifier will turn on at intervals,
in order to ventilate air around humidity
sensor, therefore get more accurate
reading on environment humidity. This
setting applies to the humidity level
setting, including the Auto mode.
1
Press the humidity button
or more times to set the desired
air humidity to 40RH%, 50RH% or
60RH% (fig. o).
» The humidity light (40, 50 or 60)
of the humidity level goes on.
» The humidity level of the
surrounding air displays on the
center of the control panel.
Tip
•
A comfortable humidity level is from
40RH% to 60RH%. You can choose
the preferred humidity level at 40%RH,
50%RH or 60%RH.
10 EN
•
If no preset humidity level is selected,
the humidifier will stop working when
the humidity level reaches 50RH% in the
auto mode and 70RH% in
once or

Water level

When there is not enough water in the
reservoir:
•
The red indicator light starts
blinking (fig. i).
•
The humidifier will stay on for
30 minutes and then turns off, and
the red indicator light remains on.
You can turn the humidifier back on
after refilling water into the reservoir.
•
If the reservoir is empty when the
humidifier is plugged in and turned
on, the red
2 minutes and then remains on before
the reservoir is refilled with water.
•
It is normal to find some water left in the
reservoir.

Refilling reservoir

one
Water level can be seen through the
transparent reservoir window.
1
Turn off the humidifier and remove
the plug from the electrical outlet.
2
Remove the upper unit by holding it
at both sides (fig. c).
3
Pour out any remaining water, rinse
reservoir, wipe clean and dry with a
clean cloth or paper towel.
4
Refill reservoir with cold tap
water until the water reaches the
maximum water indication level
(fig. g). Do not overfill.
Note
(normal) or (high) mode.
Note
indicator light blinks for
(low),