Before Using The Sound On Sound; Inserting Or Replacing Batteries - Korg Rems SOUND on SOUND Manuel D'utilisation

Before Using the SOUND on SOUND

Inserting or Replacing Batteries

The SOUND on SOUND requires two AA‐size batteries. Korg recom‐
mends that you use alkaline (LR6) or nickel‐metal hydride (NiMH) cell
batteries.
Do not combine new and used batteries or different
types of batteries.
1. Make sure that the power is switched off. All LED
indicators, and the display should also be off.
2. Remove the battery case cover.
3. If the batteries are in the case, remove them from the
case.
4. Insert two AA‐size batteries into the case with the +
and ‐ ends in the correct orientation.
5. Replace the battery case cover.
Replace the batteries with new ones when battery
power gets low.
When the batteries expire, remove them from the
case immediately. If you don't plan to use the unit
for a long period of time, remove the batteries.
Battery life varies depending on the type and manufacturer of the battery
and usage. It also varies depending on the type and manufacturer of the
memory card used and its capacity.
Battery life (when the backlight and LED indicators are turned off)
Battery type
Alkaline battery x 2
NiMH battery (1900mAh) x 2 Approx. 11 hours / Approx. 11 hours
To get accurate readings of remaining battery power, you must specify
the type of battery that is in use by accessing the BATTERY page in the
MISC category in Menu mode (see page 44).
If the battery power gets low, you can connect a dedicated AC adapter
(sold separately) to supply power while you continue using the unit.
Batteries are supplied in the package so that you can easily check the
recorderʹs operation. However, the battery life may be relatively short.
6
Continuous recording
(with the built‐in microphone)/
Continuous playback
(through headphones)
Approx. 10 hours / Approx. 10 hours