Categories, Pages, And Parameters; Input - Korg Rems SOUND on SOUND Manuel D'utilisation

Categories, Pages, and Parameters

INPUT

In this category, you can make various settings for the audio input section.
LVL CTRL
MANUAL:
This option enables you to set the input level
manually.
AUTO:
The input level is set automatically.
Low input levels are raised and high input levels
are lowered so that the entire sound level will be
more consistent. Also, if an input signal level is
excessive, the Limiter function will be activated
to compress the signal to an appropriate input level.
LEVEL
Use this parameter to adjust the input level when
the LVL CTRL parameter is set to MANUAL.
You can also use the + and ‐ buttons to adjust the
level in Record Ready mode.
Set the input level to as high as possible while lis‐
tening to the sound so that the Clip indicator
doesn't light up (60 = 0dB).
You cannot set the LEVEL parameter if the
LVL CTRL parameter is set to AUTO.
LOW CUT
If the recorder picks up faint noises, such as a
breath that hits the microphone directly, or out‐
door wind or breeze, set this parameter to ON to
cut the low frequency range to minimize the
noise.
TONE
This parameter enables you to adjust the tone of
the input sound.
LOW 1–10:
Higher values will enhance the low range.
OFF: The tone will not be adjusted.
HIGH 1–10:
Higher values will enhance the high range.
Touch slider
Touch slider
29