Canceling recording (Undo/Redo)
If you are not satisfied with your recorded performance, you can use the
Undo function to cancel the recording.
To cancel the Undo operation, use the Redo function.
The Undo/Redo operation procedure varies depending on the Undo Time
setting (see "UNDOTIME" on page 31). The factory default setting for the
number of times for the Undo operation is one (1).
When the Undo Time setting is one (1) (1TIME):
1. Press the UNDO button after recording.
2. The unit discards the latest recording and reverts to the status obtained
before recording.
The Undo LED indicator will light up.
If you start recording under these circumstances, Redo data will be
lost and the Undo LED will turn off.
3. To cancel the Undo operation (to revert to the status before you exe‐
cuted the Undo command), press the UNDO button again while the
Undo LED indicator is illuminated. (This is called a "Redo" operation.)
When the Undo Time is set to a multiple number (10TIMES or INFINITY):
1. After recording, press and hold down the UNDO
button, and press the
2. You can revert to an earlier stage (layer) of
recording with each press of the
The Undo LED indicator will light up.
At this time, the number of Undo layers will be
displayed on the LCD as long as you press and
hold down the UNDO button.
If you start recording under these circumstances, Redo data will be
lost and the Undo LED will turn off.
3. After the Undo LED indicator lights up, press and hold down the
UNDO button, and press the
You can undo and redo up to the number of times you specified for
the Undo Time setting.
button.
button.
button to redo later stages (layers).
21