Display; Turn Signal Operation; Errors - SoFlow SO4 2nd Gen Mode D'emploi Original

4.2 Display

You will find the following information on the display on the handlebar:
•
Light status
•
Battery status
•
real Time speed
•
Distance
•
Error codes
•
Bluetooth status

4.3 Turn signal operation

The control for the turn signals is located on the left side of the handlebar above the switch-on button. The turn signals are located at the end of the handlebars. They are intended to
serve as an additional indication for changing direction and are particularly visible from the onset of dusk. Please always drive with foresight and in accordance with the applicable road
traffic regulations. Bear in mind that these turn signals are a new product feature which is still unknown on the market. The indicator should be operated in good time before changing
direction. To operate the left indicator, briefly press the button with the arrow to the left once or this to the right for right. To end the function, briefly press the respective button again.
Please keep both hands on the handlebars at all times and lean slightly in the opposite direction so that the indicator can be seen better by vehicles behind you. The scooter does not
have a hazard warning light function.

4.4 Errors

The control electronics of your SO4 2ND GEN / SO4 3RD GEN/ SO4 PRO / SO4 PRO 2ND GEN continuously checks the correct function of all important components. If your SO4 2ND GEN
/ SO4 3RD GEN/ SO4 PRO / SO4 PRO 2ND GEN detects a malfunction, this will be indicated accordingly on the display. You can display the error code by briefly pressing the start button
and the minus button simultaneously:
Error message
•
E1: Communication failure
•
E2: Error with the brake
•
E3: Error with the throttle
•
E4: Error with the hall sensor
•
E5: Error with the controller
Stop using SO4/SO4 Pro immediately if the display shows one of these error messages. Switch the unit off and on again. Check the plug connection between the handlebars and the front
bar that no dirt will affect the contacts of the plugs. Make sure that the battery is fully charged. If the error message still persists, contact the SoFlow service at info@soflow.com.
copyright by www.soflow.com 19