Assembly; Device Assembly - Bosch HTD 8 Serie Notice Originale

en 28 | HTD 8xx | Product description
Use is made of the following symbols for visualisation:
Symbol Function
Indicates the battery charge status.
If the symbol appears in red, the
device needs charging with the
battery charger (included in scope
of delivery).
Indicates the PC connection status:
CONNECTED
Indicates the PC connection status:
NOT CONNECTED
Indicates the PC connection status:
DATA TRANSMITTED OR RECEIVED
NOT VALID
Touch screen key Back:
The previous mask is called up.
Touch screen key Laser:
Switch-on and switch-off of internal
laser. The key appears in green
when the laser is switched on.
Touch screen key Start
measurement:
Starts measurement. The internal
laser is switched on and the key
appears in colour. The colour
indicates the type of headlamp
(low beam – green, high beam –
blue, fog lamp – orange).
Touch screen key Live:
The display shows the live image
projected by the headlamp into the
inside of the light box.
Touch screen key Angle:
Calls up the window for
measurement of the headlamp angle
of inclination.
Touch screen key Graphics:
Calls up the window with the
graphical representation of the
measurement point projected onto
the internal screen of the light box.
Touch screen key Save:
Stores the data and transfers these
to the PC.
Touch screen key Print:
Prints the test result.
Tab. 1: Visualisation symbols
|
1 692 104 611 2014-10-15
3.5

Assembly

3.5.1

Device assembly

Assembly of the device:
1. Hold the column and remove the screw, washer,
wave spring and bearing ring from the pin.
Fig. 4: Preparing the column
2. Insert the column in the trolley. When doing so,
make sure the intermediate coupling ring is centred.
Fig. 5: Inserting the column in the trolley
3. Re-attach the bolt and washer, making sure the
bearing ring on the column is centered. Tighten the
bolt as far as possible to eliminate the play of the
stand. Tighten by a further quarter of a turn, taking
care to ensure alignment.
Fig. 6: Securing the column to the trolley
1 Trolley
2 Bolt
4. Return the device to the vertical position and check
that the trolley and column are correctly aligned and
that the column rotates properly.
Robert Bosch GmbH