JUKI DLN-6390 Manuel D'utilisation page 62

CAUTI�N �E��RE �PERATI�N
WARNING :
To avoid malfunction and damage of the machine, confirm the following.
• Be sure to fill the oil hole with oil before use.
• Clean the sewing machine thoroughly before using it for the first time.
• Remove all dust collected on the sewing machine during the transportation.
• Confirm that the voltage and phase are correct.
• Confirm that the power plug is properly connected.
• Never use the sewing machine in the state where the voltage type is different from the
designated one.
• The direction of rotation of the sewing machine is counterclockwise as observed from the
handwheel side. �e careful not to rotate it in reverse direction.
• When operating the sewing machine� turn �N the power switch after properly setting the head
on the table.
• For the first month after set-up, use the machine at a reduced sewing speed of 4,000 sti/min or less.
• �perate the handwheel after the sewing machine has totally stopped.
• Do not tilt the machine head toward this side since oil leakage or parts breakage occurs.
• �efore starting a test run� remove the bobbin case and the needle thread from the machine.
v