Atag WS9111FM Notice D'utilisation page 56

INSTALLATION
EN 14
• Place the wall socket inside the telescopic chimney.
• Connect the flange to the air extraction opening using an air duct.
• Place the bottom telescopic chimney on the cooker hood.
• Adjust the width of the hanging bracket of the upper telescopic
chimney.
• Mark off and drill the holes to attach the hanging bracket.
• Place the 2 wall plugs.
• Screw the hanging bracket to the wall with the 2 screws 'A'.
Align the hanging brackets with the cooking hood. Take the distance
to the ceiling into account.
• Slide the upper telescopic chimney from above in the bottom
section.
• Slide the upper telescopic chimney upwards and attach this to the
hanging bracket with the 2 screws 'B'.
Please note; Use the appropriate screws and plugs for mounting the
cooker hood, which are suitable for the type of wall (concrete, plaster
board, etc.) to which the cooker hood is being attached.