EdilKamin ECOIDRO Installation, Usage Et Maintenance page 36

EVERY SEASON (by the Dealer)
After 2000 kg of pellets are consumed, the display shows the word "Services???".
The stove does NOT stop, but announces the need for servicing by the Dealer.
Before carrying out any maintenance, disconnect the device from the mains power supply.
The Dealer will give you a maintenance booklet after the first Ecoidro boiler-stove ignition.
General internal and external cleaning.
Carefully clean heat exchange pipes.
Carefully clean and descale combustion chamber and corresponding compartment.
Clean motors and mechanically inspect the play and fastenings.
Clean smoke duct (replace gasket on the smoke outlet pipe) and smoke extractor fan compartment.
Check expansion tank.
Check and clean circulator pump.
Check detectors.
Check and replace the electronic circuit board clock battery if necessary.
Clean, inspect and descale ignition heating element compartment and change heating element if necessary.
Clean/check display-control panel.
Visually inspect electric cables, connections and power cord.
Clean pellet hopper and check screw feeder-gearmotor assembly play.
Check and replace the door seal if necessary.
Test screw feeder loading, ignition, operation for ten minutes, and shutdown.
Failure to carry out maintenance leads to forfeiture of the guarantee.
If the stove is used frequently, it is advisable to clean the smoke duct every 3 months.
For flue maintenance methods, also bear Italian standard UNI 10847/2000 "single flue systems for liquid and solid-fuel-fired
generators" in mind. Servicing and checking.
SUITABLE ACCESSORIES FOR EXCELLENT CLEANING
GlassKamin ash vacuum bin
36