Publicité
The following are general Warnings related to the safe setup, use, maintenance and repair of this
equipment. Additional, more specific warnings may be found throughout the text of this manual where
applicable.
Fire and Explosion Hazard
Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent
fire and explosion:
•
Use equipment only in well ventilated area.
•
Eliminate all ignition sources; such as pilot lights, cigarettes, portable electric lamps, and plastic drop
cloths (potential static arc).
•
Keep work area free of debris, including solvent, rags and gasoline.
•
Do not plug or unplug power cords, turn power switch on or off, or turn lights on or off when
flammable fumes are present.
•
Ground equipment and conductive objects in work area. See Grounding instructions.
•
If there is static sparking or you feel a shock, stop operation immediately. Do not use equipment
until you identify and correct the problem.
Equipment Misuse Hazard
Equipment misuse can cause death or serious injury.
• Do not exceed maximum working pressure or temperature rating of lowest rated system component.
See Technical Data, in all equipment manuals.
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all
equipment manuals. Read fluid and solvent manufacturer's warnings.
• Check equipment daily. Repair or replace worn or damaged parts immediately.
• Do not alter or modify this equipment.
• Use the equipment only for its intended purpose. Call your Graco distributor for information.
• For professional uses only.
• Do not use hoses to pull equipment.
• Route hoses away from traffic areas, sharp edges, moving parts and hot surfaces.
• Comply with all applicable safety regulations.
Pressurized Equipment Hazard
Exceeding maximum working pressure of any attachment can cause serious injury. Compressed air can
inject in skin. Air tubing rupture can cause injury if disconnected while under pressure. To reduce risk of
injury:
• Never exceed maximum working pressure of any attachment.
• Do not point spray gun at anyone, or put hand, fingers, or rag over nozzle or stop or deflect leaks with
your hand, body, glove or rag.
• Follow Pressure Relief Procedure, page 9 whenever you are instructed to relieve pressure, stop
spraying, service equipment, install or clean spray nozzle or disconnect or connect hose.
Sprayer Warnings
For sprayer operation and warning information refer to your sprayer or compressor operation manual.
2
Warnings
Warnings
310616J
Publicité
