Rear Panel; Front Panel - PIONEER DJ DDJ-RR Mode D'emploi

Rear panel

1
2
1 Kensington security slot
2 BOOTH output terminal
These are the output terminals for a booth monitor. Compatible with
balanced or unbalanced output for 1/4" TRS connectors.
3 MASTER 2 terminals
Connect to a power amplifier, etc.
4 MASTER 1 terminals
Connect powered speakers, etc., here.
5 PHONO/LINE input terminals
Connect a phono level (for MM cartridges) output device (analog
player, etc.) or a line level output device (DJ player, etc.). Switch
the input source according to the connected device using the
[LINE/PHONO] switch on this unit's rear panel.
6 LINE/PHONO switch
Selects the input source of each channel from the components con-
nected to this unit.
— [PHONO]: Select this to use a phono level (for MM cartridges)
output device (analog player, etc.) connected to the [PHONO/
LINE] input terminals.
— [LINE]: Select this to use a line level output device (DJ player,
etc.) connected to the [PHONO/LINE] input terminals.
! Different input sources cannot be selected for both channels.
7 PC MIX switch
— [ON]: Outputs the audio of the external device from this unit via a
computer. This enables performances using the mixer functions

Front panel

1 PHONES output terminals
Connect headphones here.
Compatible with a 1/4" TRS jack and 3.5 mm stereo mini jack.
2 HEADPHONES LEVEL control
Adjusts the level of audio output from the [PHONES] output
terminals.
3 MIC LEVEL control
Adjusts the level of audio input to the [MIC] input terminals.
3 4 5
1 2
6 78 5 9
or effect functions of rekordbox for the audio of the external
device.
! For use with this setting, be sure to connect a computer and
then start rekordbox.
— [OFF]: Outputs the audio of the external device from this unit not
via a computer. This allows you to output the audio of an external
device from this unit without connecting a computer.
! With this setting, the volume can be adjusted using the chan-
nel fader and crossfader of this unit, but functions such as
EQ and FILTER cannot be used. For the detailed operation of
each button and control, see the Operating Instructions.
8 SIGNAL GND terminal
Connects an analog player's ground wire here. This helps reduce
noise when the analog player is connected.
9 MIC input terminal
Connects a microphone here.
Compatible with a 1/4" TS jack.
USB terminal
a
Connect to a computer.
b DC IN terminal
Connect to a power outlet using the included AC adapter (with the
included power cord connected).
c Cord hook
Catch the AC adapter's power cord and USB cable on this hook
when using this unit.
d STANDBY/ON switch
This switches this unit's power between on and standby.
3
a b c d
11
En