Mixer Section - PIONEER DJ DDJ-RR Mode D'emploi

l CUE button
Press:
Sets, plays and calls out cue points.
! When the [CUE] button is pressed during pause, the cue point is
set.
! When the [CUE] button is pressed during playback, the track
returns to the cue point and pauses. (Back Cue)
! When the [CUE] button is pressed and held after the track
returns to the cue point, playback continues as long as the but-
ton is pressed. (Cue Sampler)
! When the [PLAY/PAUSE f] button is pressed during Cue
Sampler, playback continues from that point.
[SHIFT] + press:
Returns the playback position to the beginning of the track.
m SYNC button
Press:
Synchronizes with the tempos (pitches) and beat grids of the deck
set as the master for synchronization automatically.
[SHIFT] + press:
Sets the deck whose button is pressed as the master deck for
synchronization.
n SHIFT button
When another button is pressed while pressing the [SHIFT] button, a
different function is called out.
! For details on operation using the [SHIFT] button, see the
Operating Instructions.
o GRID ADJUST button
When the jog dial is turned while pressing the [GRID ADJUST] but-
ton, the beat grid interval can be adjusted.
[SHIFT] + press:
The BPM value is divided by 1/2 (doubling the beat grid's spacing).
p GRID SLIDE button
When the jog dial is turned while pressing the [GRID SLIDE] button,
the overall beat grid can be slid to the left or right.
[SHIFT] + press:
The BPM value is multiplied by 2 (reducing the beat grid's spacing
by 1/2).
q SLIP button
Turns the slip mode on and off.
[SHIFT] + press:
Turns the vinyl mode on and off.
r SLIP REVERSE button
Press:
(During normal operation)
Plays the track in the reverse direction while the [SLIP REVERSE]
button is pressed, and resumes normal playback when the button is
released.
Slip reverse play is automatically canceled after 8 beats have elapsed
even if the [SLIP REVERSE] button is kept pressed. The playback
returns to normal after reverting to the background.
(During standby status)
The standby mode is canceled.
! This is limited to the button on the left deck side.
[SHIFT] + press:
Starts reverse playback. When the [SHIFT] and [SLIP REVERSE]
buttons are pressed again, reverse playback is canceled and normal
playback resumes.
s PANEL button
Displays or hides each panel of rekordbox.

Mixer section

1
2
3
5
d
6
7
4
a
8
1 INPUT SELECT switch
Selects the input source of each channel from the components con-
nected to this unit.
! [DECK1-4]: Select this to use the track loaded in the rekordbox
deck.
If [DECK4] is used, the software takeover function operates. For
details, see the Operating Instructions.
! [PHONO/LINE]: Select this to use a line level output device (DJ
player, etc.) connected to the [PHONO/LINE] input terminals on
the rear panel.
2 TRIM control
Adjusts the individual channel output gain.
3 EQ (HI, MID, LOW) controls
Boosts or cuts frequencies for the different channels.
4 Channel Level Indicator
Displays the sound level of the respective channels before passing
through the channel faders.
5 FILTER control
Applies the filter effect for the respective channel.
The original sound is output when the control is at the center
position.
Turn counterclockwise: Gradually descends the low-pass filter's cut-
off frequency.
Turn clockwise: Gradually rises the high-pass filter's cutoff
frequency.
6 Headphones CUE button
Press:
The sound of channels for which the headphones [CUE] button is
pressed is output to the headphones.
! When the headphones [CUE] button is pressed again, monitor
output is canceled.
[SHIFT] + press:
The track's tempo can be set by tapping the button. (Tap function)
1
2
3
9
b
c
f
5
e
6
7
4
En
9