AERMEC MCR Manuel D'utilisation page 20

1 INTRODUCTION
The MCR control board has the function of controlling the active chilled beams of the EHT family.
It can be managed by one of the following user interfaces:
— VMF-E4X
— VMF-E3 (in this case, compatibility with the VMF-IR remote control is maintained)
— VMHI
VMF-E4X
STORING THE DOCUMENTATION
Consign the instructions with all the complementary documentation to the user of the accessory who will assume responsibility for the conservation of the instructions so
that these are always available in case of need.
Carefully read this document. The execution of all the works must be carried out by qualified personnel, in accordance with the national regulations.
It must be installed in such a way to make maintenance and/or repair functions possible.
Do not modify or tamper with the accessory as this may cause danger for which the manufacturer will not accept any responsibility for damages caused. The warranty is voided
if the above instructions are not followed.
2 INSTALLATION
Attention: Do not remove the pre-cut of the beam as it already has the holes provided for the installation of the MCR accessory.
To install the accessory follow the subsequent instructions (the drawing on this page shows a general installation schematic):

Note: The MCR accessory is installed on the opposite side to the fresh air. The holder, in which the electronic board is installed, is also used as a guide.
20
1
2
3
VMF-E3 VMHI
1. Fix the bracket to the beam using the holes
provided;
2. Install the circuit board in the holder and con-
nect the electrical cables;
3. Mount the cover and then cover the circuit
board.
22/04 – 5572952_00