Siemens SITRANS LR560 Manuel De Demarrage Rapide page 7

Pressure Equipment Directive, PED, 97/23/EC
Note: Pertains to pressure-rated version only.
SITRANS LR560 Radar Level Measurement instrument falls below the limits of Article 3,
sections 1&2 of the Pressure Equipment directive (PED, 97/23/EC), as a category I pressure
accessory. However, in accordance with PED, 97/23/EC, Article 3, section 3, this equipment has
been designated and manufactured in accordance with Sound Engineering Practice (SEP) (see
EU Commission Guideline 1/5).
Installation
WARNINGS:
• Installation shall be performed only by qualified personnel and in accor-
dance with local governing regulations.
• Never attempt to loosen, remove, or disassemble process connection or
instrument housing while vessel contents are under pressure.
• The user is responsible for the selection of bolting and gasket materials
which will fall within the limits of the flange and its intended use and which
are suitable for the service conditions.
• Improper installation may result in loss of process pressure.
Notes:
• For European Union and member countries, installation must be according to ETSI EN
302372.
• SITRANS LR560 units are pressure tested, meeting or exceeding the requirements of the
ASME Boiler and Pressure Vessel Code and the European Pressure Equipment Directive.
Nozzle location
Beam angle
• Beam angle is the width of the cone where
the energy density is half of the peak
energy density.
• The peak energy density is directly in front
of and in line with the antenna.
• There is a signal transmitted outside the
beam angle, therefore false targets may be
detected.
Emission cone
• Keep emission cone free of interference
from ladders, pipes, I-beams or filling
streams.
• Avoid central locations on tall, narrow ves-
sels.
7ML19985XF81 SITRANS LR560 (HART) – QUICK START MANUAL
min. 1 m (39")
emission
cone
4°
Page EN-5