Operating Instructions; Proper Pellet Loading; Start Up Cycle; Lighting Appliance Manually - Napoleon NPS45 Instructions D'installation Et D'opération

32

8.0 operating instructions

8.1

proper pellet loading

EN
Before loading pellets into the hopper fi rst transfer the pellets from it's original plastic bag to a metal bucket.
Keep in mind that the auger stops when the lid is opened. If the lid is opened for several minutes, the fi re may
extinguish.
NOTE: If the pellets are kept in the plastic bag, the bag may come in contact with the appliance caus-
ing the bag to melt and the pellets to spill.
DO NOT load pellets into the hopper if they have been exposed to moisture. Moisture can cause pellets
to swell and cause blockage in the feed system. Thoroughly dry pellets before placing into hopper.
8.2

start up cycle

Before installing this appliance we recommend a "PRE-BURN" inspection to help burn off the odours that are
associated with the first burn. If possible, move the appliance outside and add approximately 5 lbs of pellets
into the hopper. Plug the power cord into a typical wall receptacle.
The appliance is equipped with a control board that has been shipped in manual mode.
When first starting a new pellet appliance, or when you completely empty the hopper of pellets you can press
and hold the prime button to get the pellets into the burn pot quicker.
Press the ON/OFF button:
A.
The "POWER" light will come on, indicating that the start-up cycle has begun. The "HEAT" light will
B.
come on.
The auger comes on and runs for approximately 3 minutes.
C.
The igniter comes on and will stay on until the proof of fire determined by the temperature of the
D.
appliance.
The convection blower will not operate until the proof of fire is determined by the temperature of the
E.
appliance.
NOTE: Flame should appear in the burn pot within 3 to 7 minutes from commencing the start-up cycle.
The start-up cycle should end in approximately 12 to 15 minutes. At that point, the power light will go
from red to green and then adjustments to the feed rate can be made or the appliance will revert to the
previous setting. If proof of fire is not established in 15 minutes, the appliance will shut down and will
need to be turned back on again.
If the appliance shuts down, empty the pellets from the burn pot and restart.
8.3

lighting appliance manually

OTHER THAN PLACING A HANDFUL OF PELLETS IN THE BURN POT FOR LIGHTING MANUALLY,
NEVER FEED PELLETS THROUGH THE GLASS VIEWING DOOR. AN "OVERFIRE" CONDITION
COULD OCCUR, IF MORE PELLETS ENTER THE FIREBOX THAN WHAT THE FEED TUBE CAN
NEVER USE GASOLINE TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR SIMI-
LAR LIQUIDS TO START OR 'FRESHEN UP' A FIRE IN THIS APPLIANCE. KEEP ALL SUCH LIQUIDS
Your appliance can be lit manually without using the automatic igniter by following the procedure below.
• Press the ON / OFF button.
• Place a "handful" of pellets into the burn pot.
• Cover with a small amount of approved (non-volatile) fi re starter gel.
• Light fi re starter with a match and close the viewing door.
W415-1472 / B / 02.05.18
APPLIANCE MAY BE HOT.
DELIVER. PELLETS MUST ONLY BE BURNED WITHIN THE BURN POT.
WELL AWAY FROM THE APPLIANCE WHILE IT IS IN USE.
WARNING
!
47.10
47.11