Safety Features; Epa Compliance - Napoleon NPS45 Instructions D'installation Et D'opération

P.F.I. PELLET STANDARDS:
Inorganic Fines (fine
particles)
Bulk Density
Size
Ash Content
Moisture Content
Chlorides
Trace Metals
Heat Content
Construction Waste
NOTE: If the fuel does not comply to this standard, the appliance may not operate as designed.
We recommend the use of premium grade fuel (1% ash content) for longer appliance life and less
frequent cleaning.

2.4.2 safety features

HIGH LIMIT SWITCH: Your appliance is equipped with a high limit switch. In the event that the temperature
of the appliance approaches an unsafe operating temperature, this switch will shut down the pellet feed,
which will eventually shut down the appliance. If this happens, it is important to find out why the appliance
overheated. Contact your local dealer.
LOW LIMIT SWITCH: This switch will automatically shut down the appliance if the fire goes out or fails to
light within 15 minutes.
HOPPER DOOR INTERLOCK: Your appliance is equipped with a micro switch in the hopper assembly that
shuts off the auger when the hopper door is opened. Closing the door switches the auger back on, allowing
pellets to feed again.
VACUUM SWITCH: This switch will sense lack of air flow through the appliance and shut down the pellet
feed. This lack of flow could be caused by a blocked vent.
POWER FAILURE: In the event of a power failure, the appliance will shut down. Once power is restored, the
appliance will restart, unless the convection air temperature has gone above the high limit switch setting. If
this happens, contact your local dealer.

2.4.3 EPA compliance

ppliance is EPA exempt from Phase II
quisites, but complies with Oregon /
ngton emissions requirements.
1% maximum through a 1/8" (3.2mm) screen
38 pound per cubic foot minimum / 17kg per cubic meter
1/4" (6.4mm) to 5/16" (8mm) diameter, 1/2" - 1 1/2" (13mm - 38mm) long maximum
No more than 2%
8% maximum
300 parts per million by weight
Less than 100mg/kg
Approximately 8200 BTU per pound minimum
Not to contain any waste materials
We suggest that our woodburning hearth products
be installed and serviced by professionals who are
certified in the U.S. by the National Fireplace
Institute® (NFI) as NFI Woodburning Specialists or
who are certified in Canada by
Wood Energy Technical
Training (WETT).
66.1A
11
EN
W415-1472 / B / 02.05.18