28
5.4
minimum mantel clearances
EN
RISK OF FIRE, MAINTAIN ALL SPECIFIED AIR SPACE CLEARANCES TO COMBUSTIBLES. FAILURE
TO COMPLY WITH THESE INSTRUCTIONS MAY CAUSE A FIRE OR CAUSE THE APPLIANCE TO
OVERHEAT. ENSURE ALL CLEARANCES (I.E. BACK, SIDE, TOP, VENT, MANTEL, FRONT, ETC.) ARE
WHEN USING PAINT OR LACQUER TO FINISH THE MANTEL, THE PAINT OR LACQUER MUST BE
5.5
rear to top vent conversion instructions
NOTE: The insert is factory shipped in a rear vent configuration. Be careful not to damage the gasket.
If installing 4" (102mm) diameter vent vertically, it will be necessary to start with a 12" (305mm) section
of 3" (76mm) diameter vent to clear the hopper, then increase to
4"(102mm) diameter vent.
A.
To vent exit vertically, remove the 2 screws holding the
exhaust cover.
Remove the 2 screws holding the exhaust tube.
B.
Attach the exhaust tube and gasket in the vertical position.
C.
Attach the exhaust cover and gasket over the horizontal exit.
D.
W415-1472 / B / 02.05.18
WARNING
!
CLEARLY MAINTAINED.
HEAT RESISTANT TO PREVENT DISCOLOURATION.
16" MANTEL
14"
12"
10"
14"
12"
10"
8"
73.1