Johnson LIVESTRONG LS10.0E Manuel Du Propriétaire page 18

ASSEMBLY STEP 8
LS13.0E, LS15.0E SHOWN
CONSOLE
CONSOLE CABLES
CONSOLE MAST
LS10.0E UPPER
HANDLEBAR AND
HANDLEBAR COVER
18
NOTE: All hardware for this step is pre-installed.
A Remove PRE-INSTALLED HARDWARE from
CONSOLE.
B Attach the CONSOLE CABLES to the CONSOLE.
UPPER HANDLEBAR C Carefully tuck the CONSOLE CABLES into the
CONSOLE MAST before attaching the CONSOLE.
PRE-INSTALLED
Attach CONSOLE to CONSOLE MAST using 4 PRE-
SET SCREWS
INSTALLED BOLTS.
HANDLEBAR COVER
D Slide HANDLEBAR COVER over bottom of UPPER
HANDLEBAR.
PRE-INSTALLED BOLTS
E Slide UPPER HANDLEBAR onto LOWER
LOWER HANDLEBAR
HANDLEBAR making sure handlebars are joined
together completely. Secure UPPER HANDLEBAR to
LOWER HANDLEBAR using PRE-INSTALLED SET
SCREWS.
F Slide HANDLEBAR COVER down to cover hardware.
G Repeat steps D–E on other side.
NOTE: Be careful not to pinch any wires while attaching
the console. Make sure upper handlebars are as far down
as possible. Handlebars can be damaged if not secured
correctly.
ASSEMBLY COMPLETE!