Christopeit Sport TM750 S Notice De Montage Et D'utilisation page 21

Meanings of error message codes
In case of malfunctions may adjoining list of error messages help for
savvy people to get function back. Basically, electrical repairs only
in compliance with the relevant safety rules which exists. For more
information and assistance in case of malfunctions with our service
department (contact details see last page.)
Problem Potential reasons
---- The safety lock is removed
E01 Communication abnormality: abnormal
communication between the controller
and the electronic meter after powering
on.
E02 Voltage-proof protection:
E03 No sensor signal:
E05 Over-current protection:
E07/E08 EEPROM defect
Motor The motor cable is damaged or con-
will not nected incorrectly.
start The fuse on the control board has been
damaged or dropped.
The control board is defect.
The motor is defect.
Remind add oil function
When the treadmill in running sate, the total distance more than
100KM, the time windows will show time and OIL take turns, and
have the buzzer sounds, it reminds the user need add the oil. At this
state, press [STOP] button can eliminate the reminder and zero the
cumulative distance. In addition, pull out the safety key, press the
[EINGABE] and [PROG] more than 3 seconds will show cumulative
distance. If you want eliminate, press the [EINGABE] and [PROG]
more than 3 seconds again.
Training area in mm
(for home trainer and user)
Solutions
1. Put the safety clip in position
2. Change the safety clip or safety clip socket at computer.
3. If it's still not ok, than change the computer.
1. Switch off the treadmill and plug out AC cable.
2. Check each section of communication cables from the electronic meter to the controller and
ensure that all cables are well connected.
3. Check whether cables between the electronic meter and the controller are damaged; if yes,
replace the damaged wire.
1. Switch off the treadmill and plug out AC cable
2. Check whether the power supply voltage is less than 50% of the normal value. Please ensure-
correct voltage and test again.
3. Check whether the controller emits the odor of burning; if yes, replace the controller.
4. Check whether motor cables are well connected; re-connect motor wires.
1. Switch off the treadmill and plug out AC cable.
2. Check whether the sensor cable is well plugged or whether it is damaged; plug it well or
replace the sensor.
1. Check whether power supply voltage specifications is inconsistent or too low and use correct
voltage specifications for re-test.
2. System self-protection is triggered under excessive current caused by the excessive load
more than the rated value, or some place of the treadmill is jammed so that the motor cannot
rotate; thus, the system start up self-protection against excessive current under excessive
load; adjust the treadmill and restart it.
3. Check whether there is over-current sound or burning odor when the motor is running; replace
the motor.
4. Check whether the controller emits abnormal odor; replace it if yes.
Replace the control board.
Check the motor cable.
Check the fuse. Reinsert it, or replace the fuse.
Replace the control board.
Replace the motor.
Hibernation
If the treadmill is not in use the display switch off into Standby Mode.
Free area in mm
(Training area and security area
(rotating 60cm))
21
The free area in the directions of access to
the treadmill must have at least an area of
(0.6 m + the training area). During training,
there must be a free safety area behind the
treadmill of at least 2000 mm in length and
at least the width of the treadmill.