Publicité
Les langues disponibles
Les langues disponibles
Unpacking and Operation
Before usage, observe our recommendations and safety in-
structions.
Step 1:
Remove the treadmill and tools.
Remove small parts, loose packing material out of the box and then
take out with help of a second person the preassembled frame of
packaging. Put your hands below the main frame (1) and take care
of no squeezing.
Step 2:
Unfolding the support tubes (3+4)
Fold up the supports left and right (3+4). Support the two supports
(3+4) with your hand to avoid falling and the associated risk of in-
jury. Fasten this in an upright position by screwing in the support
screws (30). (Make sure that the teeth match with each other at
both sides.)
Step 3:
Positioning the handles (6+7) and the computer (5).
ATTENTION: When assembly the hand bar, please attention the
hole on the hand bar is downward.
1. Put the left handle (6) with holder at the left sidepost (3). Use
small rotary knob (57) with nylon washer (34) to lock the handle
tightly.
2. Put the right handle (7) at right sidepost (4).
3. After using for a time, if the handle is loose, please fasten the
rotary knob (57) again.
4. Flip the computer (5) until the positioning pin (62) pops in.
5. Remove the protective film from the display if present.
6. Insert the tab holder (65) into the slot on the top of the computer
(5).
15
Publicité
