A standard US type sensor is used:
Impedance (tank empty position)
Impedance (tank full position) 240 Ohm
All the dials on the market are compatible, with a few very rare exceptions.
To connect it, refer to the electrical diagram.
V-1-3- Water separating fuel filter (not provided)
To protect the engine, a water separating fuel filter is fitted to the engine fuel supply line.
The predefined location is in the console. As the attachments are pass-through, make sure that the
zone is made water-tight during assembly.
Ref.
DESCRIPTION
1
Water/fuel separator filter
Replaceable filter cartridge
2
Make sure that there is no water in the metal bowl each time you use your boat:
-
Slightly unscrew the drain cap (do not remove it completely);
-
Drain the water;
-
Screw the drain cap back on if only petrol remains in the bowl.
Repeat the operation more often if your engine does not run properly.
613770 A
INSTALLATION AND CIRCUIT: FUEL
WARNING!!!
IT IS VITAL TO HAVE A GAUGE DIAL. IT IS SUPPLIED WITH THE
ENGINE. IF IT IS NOT PROVIDED, CONTACT YOUR DEALER.
30 Ohm
2
1
Page 38 / 65
Edition 2