BUOYANCY CHAMBER - INFLATING THE BUOYANCY CHAMBER
II-3 SECURING THE PROTECTIVE FLAP
1
2
3
After fastening the internal protective flap to the hull, pull the buoyancy chamber forward gently to
pass the external protective flap over the front tip (do not attach it at this stage). Then pull the
buoyancy chamber back.
Next, inflate
NOTE:
613770 A
Position the internal protective flap
Fasten the internal protective flap (screws + washers)
The external protective flap must be fastened finally
after the buoyancy chamber is inflated
Page 28 / 65
Edition 2