Buoyancy Chamber; Buoyancy Chamber Assembly On The Hull Open 4.2 / Open 4.8 - Zodiac OPEN 3.1 Manuel Du Propriétaire

BUOYANCY CHAMBER – Installing the buoyancy chamber on the hull

BUOYANCY CHAMBER

II-1 BUOYANCY CHAMBER
Your boat's buoyancy chamber is made from STRONGAN DUOTEX
NEOPRNE CSM-CR 1100 Decitex, 1050 gr/m².
The maintenance recommendations are specified in VOLUME I of the owner's manual.
II-2 BUOYANCY CHAMBER ASSEMBLY ON THE HULL OPEN 4.2 / OPEN 4.8
IF THE BUOYANCY CHAMBER WAS STORED AT A TEMPERATURE BELOW 0°C,
LEAVE IT IN A TEMPERATE LOCATION (20°C) FOR 12 HOURS BEFORE
UNFOLDING.
YOU CAN INFLATE THE NON-FITTED BUOYANCY CHAMBER (pressure 240mb)
AND LET IT STABILIZE FOR AROUND ONE HOUR. THEN DEFLATE IT.
NOTE: the buoyancy chamber is fitted to the hull with the buoyancy chamber deflated
1
In order to facilitate the fitting of the buoyancy chamber, apply liquid soap to the hull's rails (A).
2
Place the buoyancy chamber bolt rope (a) in the hull rail (b) starting with the front of the hull. Pull
the buoyancy chamber to bring it to the water guard near the transom.
3
Repeat for the other side of the buoyancy chamber.
The 2 protective flaps (sealing and exterior) should pass over the hull's nose.
613770 A
®
1100 Decitex, 1000 gr/m² or
Page 27 / 65
E
N
G
L
I
S
H
Edition 2