Shutting Down/Dismantling; Disposal And Returns - Phoenix Mecano RK ROSE+KRIEGER EP-II Notice D'assemblage

7.5 Shutting down/dismantling

Before starting any work on the linear unit, any electrical drives used are to be protect-
ed against accidental switching on.
If a linear unit is installed in an oblique or vertical position, the guidance slide drive must be secu-
red against slipping during dismantling. The system is to be freed from any loads or forces.
Following a collision, the tapped spindle, guide nut, track rail guide and guide carriage have to be
replaced – even if there is no visible damage. Spare parts information is to be taken from the spa-
re parts list for the relevant linear unit type.

7.6 Disposal and returns

The linear unit must either be disposed of in an environmentally friendly way according to the ap-
plicable policies and regulations, or returned to the manufacturer.
The manufacturer reserves the right to charge for disposing of this linear unit.
7. Working life
41