Publicité
Les langues disponibles
Les langues disponibles
USE & CARE
Fan Controls:
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID
STATE SPEED CONTROL DEVICE.
The fan comes complete with a 115V cord & plug. A suitable outlet needs to be located in a suitable location near the fan.
WARNING:
ALL WIRING SHOULD BE PERFORMED BY A QUALIFIED ELECTRICIAN FOLLOWING LOCAL CODES
AND REGULATIONS.
CAUTION:
TIE OFF THE EXCESS CORD SO THAT IT WILL NOT GET CUT IN THE FAN.
MAINTENANCE
!
WARNING:
MOTORS ARE EQUIPPED WITH AUTOMATIC OVERLOAD PROTECTION AND MAY RESTART WITHOUT
WARNING. ALWAYS DISCONNECT FROM POWER BEFORE ATTEMPTING TO SERVICE.
Moving parts,
disconnect power
before servicing.
These fans are used in a variety of applications and therefore maintenance schedules will vary. In general no more than 1/6" of dirt
build-up should occur on blade, motor and guard for proper fan operation and to prevent premature failure. The complete fan should
be wiped down on a regular basis to maintain the high efficiency of the fan. Particular care should be taken to clean fan blades front
and back, and guards for better air moving performance. The motor should be kept clean to prevent overheating and premature failure.
As with all mechanical equipment scheduled inspections should include checking that all hardware is secure and blade set screws are
tight. We suggest as a minimum, that this be performed at the start and twice more every season.
WARNING:
DO NOT PRESSURE WASH THE MOTOR. THE MOTOR IS TOTALLY ENCLOSED, BUT IT IS NOT
SEALED.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A) Use this unit only in the manner intended by the manufacturer. If you have questions, contact
the manufacturer.
B) Before servicing or cleaning unit, switch power off at service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent warning device, such as a
tag to the service panel.
M-HAF18 - 11/09/17
CANARM LTD.
2157 PARKEDALE AVE. PO BOX 367
BROCKVILLE, ONTARIO K6V 5V6
TELEPHONE: (613) 342-5424
FAX: 1-800-263-4598
E-MAIL: agsales@canarm.ca
CANARM LTEE.
2555 RUE BERNARD LEFEBVRE
LAVAL, QUEBEC H7C 0A5
TELEPHONE: (450) 665-2535
FAX: (450) 665-0910
E-MAIL: agsales@canarm.ca
ARTHUR MANUFACTURING FACILITY
#7686 CONCESSION 16, RR4
ARTHUR, ONTARIO N0G 1A0
TELEPHONE: (519) 848-3910
FAX: (519) 848-3948
E-MAIL: agsales@canarm.ca
Page 3 of 3
Publicité
