Use Of A Locking Clip - Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi

Installing your child restraint in the vehicle - Rear Facing mode
6. The picture shows the correct belt path
when the child restraint is attachd to the
6
vehicle using a lap/shoulder belt.
Make sure the child restraint is properly
leveled as explained on page 29.
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the seat belt anchors.

USE OF A LOCKING CLIP

Should your vehicle belt need a locking clip, a
standard one can be purchased in specialized
retailers or through Peg-Perego Customer
Service.
To install the locking clip, hold the shoulder strap
and lap belt together just above the buckle.
Unbuckle the belt while holding the straps. Hook
the locking clip around both straps as shown.
Leave 1/2 inch space between the clip and
latch. Re-buckle the belt.
- 37 -