Table des Matières
Publicité
Installing your child restraint in the vehicle - Rear Facing mode
REAR FACING MODE USING LAP/
SHOULDER BELT (TYPE II)
1. Recline the child restraint to the rearfacing
position as shown in the picture. To recline
the child restraint, pull the handle located
below the front edge of the shell (A) as shown
in detail. An audible "click" is heard when the
seat is properly locked into position.
Note: for easier adjustment, lift the back of the
seat slightly with your free hand to remove
some weight from the mechanism.
2. Lean
the
reclined
unoccupied, on the selected vehicle seat.
3. Pull the vehicle belt at full available length
and thread both the lap and shoulder portion
of the belt through the openings under the
seat area as shown in the picture.
Note: for easier threading, turn the seat at a 45
degree angle, thread the latch plate throught
the first opening, reach under the front of the
seat and thread through the second opening.
child
restraint,
- 35 -
1
A
B
A
2
3
Publicité
Table des Matières
