Bosch BLAZE GLM 42 Consignes De Sécurité/D'utilisation page 23

161'00" ⁄
value in the memory is deleted.
Deleting the Memory
To delete the measurements stored in a given memory
position, simply press the Clear/ On/Off button 5 [ ]
while on the measurement you want to delete.
To delete all values in the memory, press the 4 button
and the On/Off button 5 [ ] at the same time, then
release the On/Off button 5 [ ].
Measured or calculated values can be added or sub-
tracted.
Adding Values
The following example describes the addition of areas:
Measure an area as described in section "Area Mea-
surement", see page 19.
Press the plus button 3 [ ]. The calculated area and
the symbol "+" will be displayed.
Press the measure button 2 [ ] to start another area
measurement. Measure the area as described in sec-
tion "Area Measurement" see page 19. Once the sec-
ond measurement is complete, the result of the sec-
ond area measurement is displayed below. To show
the end result, press the measure button 2 [ ] once
more.
2610051599 03-18 GLM42.indd 23
If there is no value yet saved to memo-
20
ry, 0'00" is shown at the bottom of the
display and "0" at the top.
The oldest value is located in position
1 in the memory, while the newest
value is in position 20 (when 20 mea-
suring values have been taken). If an
additional measurement beyond the
20th measurement is taken, the oldest
Adding/Subtracting Values
-23-
3/23/18 9:52 AM