Information Code - Samsung MS14K6000 Serie Manuel D'utilisation

Problem
Pressing the +30s This happens when the
button operates the oven was not operating.
oven.
Turntable
There is no roller ring,
While turning, the
turntable comes out or the roller ring is not
of place or stops properly in place.
turning.
The turn table drags The roller ring is not
while turning. properly in place, there
is too much food, or the
container is too large
and touches the inside
of the microwave.
The turn table rattles Food residue is stuck to
while turning and is the bottom of the oven.
noisy.
NOTE
If the above guidelines do not enable you to solve the problem, then contact your
local SAMSUNG customer service center.
Please have the following information ready:
• The model and serial numbers, normally printed on the rear of the oven
• Your warranty details
• A clear description of the problem
MS14K6000AS_AC_DE68-04345R-01_EN.indd 37
Cause Action
The microwave oven is
designed to start operating
when you press the +30s
button if it was not operating.
Install the roller ring and then
try again.
Adjust the amount of food and
do not use containers that are
too large.
Remove any food residue stuck
to the bottom of the oven.

Information code

Code Description
Control buttons are
C-d0 pressed over 10
seconds.
The GAS Sensor is
open.
C-10
The GAS Sensor is
shorted.
NOTE
If the suggested solution does not solve the problem, contact your local SAMSUNG
Service Center.
Action
Clean the keys and check if there
is water on the surface around the
keys. If this occurs again, turn off
the microwave oven for more than
30 seconds, and then try setting
again. If this code appears again, call
your local Samsung service center.
Unplug the power cord of the oven,
and then contact a local Samsung
service center.
English 37
12/26/2017 7:03:29 PM