General Notes; Structure Of The Operating Instructions; Exclusion Of Liability; Safety Instructions - Helios ETR Instructions D'installation Et D'utilisation

Installation and Operating Specification ETR

1 General notes

Compliance with the following instructions is mandatory to ensure the functionality and
safety of the product. If the following instructions given especially but not limited for
general safety, transport, storage, mounting, operating conditions, start-up, mainte-
nance, repair, cleaning and disposal / recycling are not observed, the product may not
operate safely and may cause a hazard to the life and limb of users and third parties.
Deviations from the following requirements may therefore lead both to the loss of the
statutory material defect liability rights and to the liability of the buyer for the product that
has become unsafe due to the deviation from the specifications.

1.1 Structure of the operating instructions

Before installation and start-up, read this manual carefully to ensure correct use!
We emphasize that these operating instructions apply to specific units only, and are in
no way valid for the complete system!
Use these operating instructions to work safely with and on the device. They contain
safety instructions that must be complied with as well as information that is required for
failure-free operation of the device.
Keep these operating instructions together with the device. It must be ensured that all
persons that are to work on the device can refer to the operating instructions at any time.

1.2 Exclusion of liability

To allow for future developments, construction methods and technical data given are
subject to alteration. We do not accept any liability for possible errors or omissions in the
information contained in data, illustrations or drawings provided.
We accept no liability for damage caused by misuse, incorrect use, improper use or as a
consequence of unauthorized repairs or modifications.

2 Safety instructions

Mounting, electrical connection, and start-up operation may only be carried out by an
•
electrical specialist in accordance with electrotechnical regulations (e.g. DIN EN 50110
or DIN EN 60204)!
Persons entrusted with the planning, installation, commissioning and maintenance
•
and servicing in connection with the device must have the corresponding qualifica-
tions and skills for these jobs. In addition, they must be knowledgeable about the
safety regulations, EU directives, rules for the prevention of accidents and the corre-
sponding national as well as regional and in-house regulations.
The equipment is to be used solely for the purposes specified and confirmed in the
•
order. Other uses which do not coincide with, or which exceed those specified will be
deemed unauthorised unless contractually agreed. Damages resulting from such
unauthorised uses will not be the liability of the manufacturer. The user will assume
sole liability.
It is strictly forbidden for work to be carried out on any components while they are
•
connected to live voltage.
L-BAL-E293-GB 1841 Index 001 Part.-No.
4/19
General notes