Troubleshooting - Fagor LUX 360 Manuel D'utilisation

Troubleshooting

I f the LUX 360 detects an internal error or a wrong connection, it will show an error
code on the display panel and will stop functioning. These codes will allow you to
identify the cause of the error and help you find the solution to the problem. If the error
persists, please call our customer service department for assistance at 1-800-207-
0806.
E1: Internal circuits have disconnected.
Self-help: Call our customers service department for assistance.
E2: The internal sensor has short-circuited or the unit is overheating.
Self-help: Try to cool the unit by turning it off and unplugging as well as
removing the cooking pot.
E3: Unit is overheating.
Self-help: Try to cool the unit by turning it off and unplugging as well as
removing the cooking pot. If the E3 message persists, the cooking
pot or heating plate may be deformed. You will need to contact
our customer service department.
E4: Pressure switch has malfunctioned.
Self-help: Check the cooking pot for warping. Check the heating plate for
any food residue.
Problem
• Please be advised that the lid can't be opened until the floating
The lid cannot
valve drops down.
be opened at
• Make sure you turn the regulator to steam until all internal
the end of the
pressure is released and the lid opens easily.
cooking cycle
• If this occurs frequently, the gasket may need to be adjusted.
• Close the lid correctly ensuring there is no gap between lid and
Steam is base.
escaping from • Ensure the silicone gasket is clean, free from damage or cracks
the lid and is properly inserted.
• If problem persists, call our customer service department.
Easy Solution
38
• Close the lid correctly ensuring there is no gap between lid and
base.
Self-locking pin • Ensure the silicone gasket is clean, free from damage or cracks
does not rise and is properly inserted.
• Ensure that the self-locking pin can move freely.
• If problem persists, call our customer service department.
• Ensure that the pressure regulator valve is properly placed in
Cooker is not its housing.
getting to • Add more liquid/food to the bowl. There should be a minimum
pressure of 1 cup of food and liquid in total.
• If problem persists, call our customer service department.
• When the lid is locked, ensure the self-locking pin is properly
secured.
• Ensure that the pressure regulator valve is properly placed in
Timer will not
its housing.
count down
• Add more liquid/food to the bowl. There should be a minimum
of 1 cup of food and liquid in total.
• If problem persists, call our customer service department.
Water is • Ensure the cooker is on a flat, level surface and that the
collecting on the condensation drip cup is installed on the side of the cooker.
countertop • Empty the condensation drip cup.
• Ensure that the lid is on the correct position. For Brown and
The unit is Sauté the lid needs to be off. If the lid is closed under these
beeping and not functions the unit will beep and an icon will indicate to open the
turning on lid. For all other functions, the lid must be closed. If the lid is
open the unit will beep and an icon will indicate to close the lid.
Floating Valve Installation
Floating Valve
Floating Mini Gasket
Figure: Floating valve Installation
Insert the floating valve from the top of the lid and secure it in place with the washer from the bottom of
the lid.
Floating valve
Floating Mini Gasket
39