Installation; Installation References For Fire Resistance; Installation Description Dt 600C; Installation Descriptiondt 600C Fh - Häfele DT 600c Instructions D'utilisation

5. Installation

The installation descriptions for the DT 600c / DT 600c FH / DT 600c FH - EN 1125 door
terminals are separate documents. The installation steps that differ for the outdoor version are
integrated into the installation descriptions.
They can be accessed via the QR code on the enclosed information sheet or under the
respective catalogue number at www.hafele.com

5.1 Installation references for fire resistance

DANGER
Risk due to unsealed drill hole!
With fire resistant doors, the drill hole of the profile cylinder must be sealed so that no
flames can penetrate through.
• Only use a single profile cylinder with fire protection approval for the emergency
opening.
Planning may only be carried out by DIALOCK specialists. Door fittings for fire
resistant and smoke control doors, e.g. the DT 600c FH / DT 600c FH - EN 1125, must
be approved by the door manufacturer. If the terminal is installed without this approval,
the Fire and Smoke Control Certificate for the fire resistant or smoke control door will
be invalidated.

5.2 Installation description DT 600c

The installation is described entirely in pictures

5.3 Installation descriptionDT 600c FH

The installation is described entirely in pictures

5.4 Installation description DT 600c FH - EN 1125

The installation is described entirely in pictures

5.5 Installation description for the outdoor version

The installation steps that differ for the outdoor version are integrated into the installation

descriptions
46
5.2–5.4

DT 600c .

DT 600c FH .

DT 600c FH - EN 1125 .