Publicité
Les langues disponibles
Les langues disponibles
English
3.3 Kebbe accessory instructions
1. With the machine disconnected, attach the mincing head (6) to the motor
unit. Insert the mincing head into the slot on the motor unit whilst pressing
the connection button (5), you will hear a click when it is attached (Figure 1).
Once attached, rotate the head softly until the neck is locked perpendicular.
(Figure 2)
2. Insert the feed screw (7) through the mouth of the mincing head, attaching
it to the motor unit output shaft. (Figure 3)
3. Attach the sausage plate (13) to the kebbe accessory (14), aligning the
notches on each part. Insert the resulting assembly into the head so that the
slot lines up with the cotter located inside the head and fix the assembly by
rotating the cap (10) onto the threaded rim of the head.
4. Attach the tray (1) onto the neck of the mincing head.
5. The machine is now ready to start using the kebbe accessory and you can
now connect it to the mains.
6. Place the mincemeat on the tray.
7. Press the ON/OFF button (3) and the feed screw starts to turn. Insert the
mincemeat into the neck with the help of the food pusher. The meat will start
to exit the head.
21
Publicité
