STERWINS 20VHT2-50.1 Notice De Montage, Utilisation Et Entretien page 224

4.1 UNBOXING
FR
6
ES
PT 7
IT
EL
8
PL
RU
KZ
• Wear gloves when unboxing.
UA
• Do not use cutter, knife, saw or any other similar tool for unboxing.
• Carry the tool only by the handle (6).
RO
• Keep the box for further reuse (transport and storage).
EN
• Keep instruction manual in a dry area for further consultation.
4.2 INSTALLATION
Blade cover : illustration 2.1
Remove the blade cover 8 from the blade 2 before operation
Align and push the blade cover 8 onto the blade 2 to attach it.
NOTE: Always attach the blade cover 8 when the product is not in use, for storage and transportation.
Installing/Removing the battery pack : illustration 2.2
WARNING : Make sure the latch on the bottom of the battery pack snaps in place and the battery pack is
fully seated and secure in the product's battery docking port before beginning operation.
Failure to securely seat the battery pack could cause the battery pack to fall out, resulting in serious
personal injury.
To install : To attach, align and slide the battery pack onto the slots of the battery docking port until it
locks in place.
To remove : To release, press the battery unlock button and remove the battery pack from the product.
5
4
3
1
1. Cutting bar
2. Blade
3. Guard
4. Front handle with safety switch
5. Lock switch
2
6. Rear handle
7. On/off switch
8. Blade cover
224