Cleaning The Thermal Head - Epson TM-L90 Manuel De L'utilisateur

English
Do not block the label peeler detector with your fingers, or anything else while the label
issuing is in progress. This may cause the printer to feed the following label.
CAUTION:
When installing roll paper, be careful not to injure your hands on the manual
cutter.
Troubleshooting
ERROR LED is on or flashing
❏
Make sure that the roll paper cover is closed and the PAPER OUT LED is not
on. Close the cover or replace the paper if necessary.
❏
If the printer has been printing a lot and the print head gets too hot, the
ERROR LED starts flashing, and printing stops. When its temperature cools
down to the normal range, printing resumes automatically.
❏
Turn off the printer and then turn it back on. If the LED is still flashing,
consult with your supervisor or a service person.
PAPER OUT LED is flashing
If the PAPER OUT LED continues to flash even after the issued label is removed,
the label peeler detector may be detecting something. Press the PAPER FEED
button once.
Paper jam
Turn off the power, open the peeler cover, and then open the roll paper cover to
check for a paper jam. If there is a paper jam, remove the jammed paper and
follow the instructions in the Installing Roll Paper section to prepare the printer
for printing.

Cleaning the Thermal Head

CAUTION:
After printing, the thermal head can be very hot. Be careful not to touch it and
to let it cool before you clean it. Do not damage the thermal head by touching
it with your fingers or any hard object.
Epson recommends cleaning the thermal head periodically (generally every 6
months) to maintain receipt print quality.
1. Turn off the printer, open the peeler cover, and then the roll paper cover.
2. Clean the thermal element of the print head with a cotton swab lightly
moistened with an alcohol solvent (ethanol or IPA), as shown in the
illustration.
.
3. Close the roll paper cover after the alcohol solvent has dried.
8 TM-L90 with Peeler User's Manual